User Tools
sputter:pellet
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
sputter:pellet [2011/08/17 09:35] 132.235.40.233 Split some steps so each action is a numbered step, fixed some spelling and grammar, added some additonal detail /JEO |
sputter:pellet [2016/04/26 11:02] carter [(Revised 4/15/2009; Rev. 17 Aug 2011)] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Cesium Sputter Source Target Change ====== | ====== Cesium Sputter Source Target Change ====== | ||
| - | ===== (Revised 4/15/2009; Rev. 17 Aug 2011) ===== | + | ===== (Revised 4/15/2009; Rev. 17 Aug 2011; Rev. 26 April 2016) ===== |
| Line 38: | Line 38: | ||
| - Remove the small ground hook from the source head. | - Remove the small ground hook from the source head. | ||
| - Open gate valve between source and inflection magnet. | - Open gate valve between source and inflection magnet. | ||
| - | - Remove large ground hook from power platform and close gate. The orange lights on Glassman power supplies should light up, if not, try pushing the boost button on the wall. If this still does not make the lights come on, wait a few minutes and try again (leave gate open while waiting to let the actuator cool). | + | - Remove large ground hook from power platform and close both gates. The orange lights on Glassman power supplies should light up, if not, try pushing the boost button on the wall. If this still does not make the lights come on, wait a few minutes and try again (leave gate open while waiting to let the actuator cool). |
| - | - Use long Plexiglas rod to push the two High Voltage ON buttons located on the top two Glassman Power Supplies. | + | - Press the doorbell button on top the Pelletron AC Power Center. The Extractor and Target Glassman supplies should indicate Voltage Control with red lights. |
| - In control room, turn on Del Main Extractor supply to the previous value. | - In control room, turn on Del Main Extractor supply to the previous value. | ||
| - Return ionizer to 21 A. | - Return ionizer to 21 A. | ||
sputter/pellet.txt · Last modified: 2020/07/27 14:08 by jacobs
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
