This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
playground:startup [2023/09/07 04:14] carter |
playground:startup [2023/09/07 04:21] carter |
||
---|---|---|---|
Line 63: | Line 63: | ||
**4. Beam Transport** | **4. Beam Transport** | ||
- | a. Use the magnet predictor tool and set Quad 1 to the predicted value. | + | a. Use the magnet predictor tool and set Quad 1 to the predicted value. Do not make large abrupt changes to the Quad 1 current. If a large abrupt change in current is attempted, the power supply may begin oscillating. To stop this oscillation, run the current slider to zero then re-adjust to the desired current at a slower non-abrupt rate. |
b. Tune beam and send it around the properly configured Analyzing Magnet. | b. Tune beam and send it around the properly configured Analyzing Magnet. |