Differences

This shows you the differences between two versions of the page.

--- playground:startup [2012/06/01 10:25]
carter
+++ playground:startup [2012/06/29 09:27]
carter
@@ Line 1: / Line 1: @@
 ====== Accelerator Start-up ======
-.	**Initial Machine Voltage setup:**
+.	**Verify Initial Machine Voltage setup:**
 Initial conditions on TPS:
@@ Line 58: / Line 58: @@
 **4.	Beam Transport**
-a.	Tune beam and send it around the properly configured Analyzing Magnet.
+a.      Use the magnet predictor tool and set Quad 1 to the predicted value.
-b.	You may need to make adjustments to the TERMINAL VOLTAGE dial to get the terminal to the proper energy for transmission around the magnet and fairly balanced current on the slits.
+b.	Tune beam and send it around the properly configured Analyzing Magnet.
-c.	When current is present on the LE and HE Slit current meters you may then switch the Control Mode to AUTO (middle position) and the SLIT control light should illuminate.  If there is instability in slit control you may try raising the CONTROL GAIN more.
+c.	You may need to make adjustments to the TERMINAL VOLTAGE dial to get the terminal to the proper energy for transmission around the magnet and fairly balanced current on the slits.
-d.	When in AUTO control the machine will go back to GVM control anytime the beam is interrupted.
+d.	When current is present on the LE and HE Slit current meters you may then switch the Control Mode to AUTO (middle position) and the SLIT control light should illuminate.  If there is instability in slit control you may try raising the CONTROL GAIN more.  If the slit currents are not balanced when in slit control, make slight adjustments in the CHARGING VOLTAGE to balance the slit currents.
+e.	When in AUTO control the machine will go back to GVM control anytime the beam is interrupted.

Accelerator Handbook

User Tools

Site Tools

Differences

Page Tools