User Tools

Site Tools


playground:shutdown

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision
Previous revision
playground:shutdown [2009/03/04 15:46]
127.0.0.1 external edit
playground:shutdown [2017/04/17 11:45] (current)
jacobs
Line 1: Line 1:
-==== Machine ​Shutdown ====+==== Accelerator ​Shutdown ====
  
-** Machine Shutdown **+1. Switch OVERVOLTAGE PROTECTION to DISABLE.
  
-   1. Log Machine settings, log radiation monitor tape if necessary. +2. Switch ​the control mode to GVM. 
-   2. Switch ​stabilizer ​to "​AUTO"​ + 
-   ​3. Put cup in -- when putting in L.E.  ​cup at high terminal ​voltage ​be prepared ​to run belt charge down as terminal ​voltage ​will increase when the beam loading is removed. +3. Slowly turn the CONTROL GAIN to zero while watching the grid voltage.  ​If the grid voltage ​rises above -5 volts, reduce the CHARGING VOLTAGE ​to keep the grid voltage ​less than -volts, ​then continue reducing ​the CONTROL GAIN to zero
-   4. Switch stabilizer to "​STANDBY"​. + 
-   5. Turn "​GRIDDED VOLTAGE TUBE LENS" ​ down and then push the " button+4. Turn the CHARGING VOLTAGE dial down to 0.10 
-   6. Run belt charge down. + 
-   7. Turn belt charge "​OFF"​. +5. Switch CHAIN MOTORS ​to OFF. 
-   8. Turn drive motor "​OFF"​. + 
-   9. Start Source shut down (all control room operations). +6. Switch ​POWER SUPPLIES ​to OFF. 
-  10. Set steerers to zero and the to "​OFF"​. + 
-  11. Run magnets and quadrupole lenses ​down ( coarse ​to zero, fine to 500),  the punch the "​power"​ button+7. Turn ​the TERMINAL VOLTAGE dial to zero.
-  12. Turn the beam profile monitor ​ (BPM) to "​STANDBY"​ +
-  13Turn buncher and chopper power to "OFF"+
-  14. Run low energy extension (L.E. EXT.) einzel lens down. +
-  15. Switch ​stabilizer ​to "OFF"+
-  16. Turn key switch "​OFF"​. +
-  17. Complete source shut down in vault.+
  
  
playground/shutdown.1236199615.txt.gz · Last modified: 2009/04/15 15:30 (external edit)