User Tools

Site Tools


playground:nmr

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Last revision Both sides next revision
playground:nmr [2012/04/18 17:22]
carter
playground:nmr [2015/05/20 10:05]
carter
Line 6: Line 6:
    - You may have to adjust the VERTICAL POSITION control to find the horizontal line.    - You may have to adjust the VERTICAL POSITION control to find the horizontal line.
    - Set the HORIZONTAL SWEEP to 60.    - Set the HORIZONTAL SWEEP to 60.
-   - Recycle the analyzing magnet if needed. ​ This is done using the RECYCLE button on the analyzing magnet control window.+   - Recycle the analyzing magnet if needed. ​ This is done using the RECYCLE button on the analyzing magnet control window(NumLock must be off).
    - Set the analyzing magnet power supply to a current slightly lower than the current predicted for this energy.    - Set the analyzing magnet power supply to a current slightly lower than the current predicted for this energy.
-   - Set the TUNING VERNIER control to about mid range on its 10 turn control. ​ Rotate counterclockwise until stop then 5 turns clockwise.+   - Set the TUNING VERNIER control to about mid range on its 10 turn control. ​ Rotate counterclockwise until it stops then rotate ​5 turns clockwise.
    - Select a frequency about 1% less than the frequency desired for the beam energy.    - Select a frequency about 1% less than the frequency desired for the beam energy.
    - In the light yellow (Tandem) window type the command "​nmrgoto 1234.567"​ where 1234.567 is the frequency calculated in the previous step.    - In the light yellow (Tandem) window type the command "​nmrgoto 1234.567"​ where 1234.567 is the frequency calculated in the previous step.
playground/nmr.txt ยท Last modified: 2021/04/01 11:11 by carter