User Tools
playground:change
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
playground:change [2012/06/01 10:31] carter |
playground:change [2017/04/17 11:47] (current) jacobs |
||
|---|---|---|---|
| Line 4: | Line 4: | ||
| - Switch OVERVOLTAGE PROTECTION to DISABLE. | - Switch OVERVOLTAGE PROTECTION to DISABLE. | ||
| - Switch the control mode to GVM. | - Switch the control mode to GVM. | ||
| - | - Slowly turn the CONTROL GAIN to zero while watching the grid voltage. If the grid voltage rises above 10 volts, reduce the CHARGING VOLTAGE to keep the grid voltage less than 10 volts, then continue reducing the CONTROL GAIN to zero. | + | - Slowly turn the CONTROL GAIN to zero while watching the grid voltage. If the grid voltage rises above -5 volts, reduce the CHARGING VOLTAGE to keep the grid voltage less than -5 volts, then continue reducing the CONTROL GAIN to zero. |
| - | - To go to a higher energy move the CORONA PROBE POSITION "OUT" while raising the CHARGING VOLTAGE. **__NEVER__** allow the GRID VOLTAGE to go more negative than -10 VDC during this operation. | + | - To go to a higher energy move the CORONA PROBE POSITION "OUT" while raising the CHARGING VOLTAGE. **__NEVER__** allow the GRID VOLTAGE to go more negative than -5 VDC during this operation. |
| - | - To go to a lower energy move the CORONA PROBE POSITION "IN" while lowering the CHARGING VOLTAGE. **__NEVER__** allow the GRID VOLTAGE to go more negative than -10 VDC during this operation. | + | - To go to a lower energy move the CORONA PROBE POSITION "IN" while lowering the CHARGING VOLTAGE. **__NEVER__** allow the GRID VOLTAGE to go more negative than -5 VDC during this operation. |
| - Set the TERMINAL VOLTAGE Dial to the desired value. The dial is 2 turns per MV (set the dial to twice the GVM you want). You may have to add some upcharge after setting the dial. | - Set the TERMINAL VOLTAGE Dial to the desired value. The dial is 2 turns per MV (set the dial to twice the GVM you want). You may have to add some upcharge after setting the dial. | ||
| - Raise the CONTROL GAIN to 2-3 for low current beams, around 5 for high current beams. The system is now controlling in GVM mode. | - Raise the CONTROL GAIN to 2-3 for low current beams, around 5 for high current beams. The system is now controlling in GVM mode. | ||
playground/change.txt · Last modified: 2017/04/17 11:47 by jacobs
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
