This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
playground:pulsing [2012/02/15 11:08] jacobs |
playground:pulsing [2012/06/01 10:10] carter |
||
---|---|---|---|
Line 24: | Line 24: | ||
- Adjust H.E. steering, quads, tweaking magnet, etc. to maximize beam current. | - Adjust H.E. steering, quads, tweaking magnet, etc. to maximize beam current. | ||
- Adjust auxiliary width for beam current; this will affect both beam current and timing and will need to be set when the final timing is set. | - Adjust auxiliary width for beam current; this will affect both beam current and timing and will need to be set when the final timing is set. | ||
- | - Examine beam pick-off repetition rate; if you have adjusted the chopper and buncher properly it should read the proper frequency for the f/n you are using. See the repetition rate list. | + | - Examine beam pick-off repetition rate; if you have adjusted the chopper and buncher properly it should read the proper frequency for the f/n you are using. [[See the repetition rate list]]. |
- Send the time-tuned beam to target | - Send the time-tuned beam to target | ||
- Make final adjustments as necessary using detector timing if needed | - Make final adjustments as necessary using detector timing if needed | ||
+ | {{playground:pulsing.pdf|Original HVEC Pulsing and Bunching instruction manual.}} |