User Tools

Site Tools


playground:pulsing

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revision Both sides next revision
playground:pulsing [2009/04/16 10:57]
132.235.40.233
playground:pulsing [2010/11/10 06:16]
75.105.208.104
Line 16: Line 16:
    - Turn "​chopper power" on.    - Turn "​chopper power" on.
    - Turn buncher on.    - Turn buncher on.
-   - Bring amplifier plate to 1 keV for for deuteron or protons, 0.2-0.4 ​keV for He-3 and He-4, and 0.5-0.75 ​keV for Li-7.+   - Bring amplifier plate to 1 kV for for deuteron or protons, 0.2-0.4 ​kV for He-3 and He-4, and 0.5-0.75 ​kV for Li-7.
    - Adjust buncher phase for maximum current.    - Adjust buncher phase for maximum current.
    - Adjust buncher tuning for peak output current by cranking the tuning knob.    - Adjust buncher tuning for peak output current by cranking the tuning knob.
Line 25: Line 25:
    - Make sure proper doors are closed, and target cooling, etc. are on and take the beam into the target area.    - Make sure proper doors are closed, and target cooling, etc. are on and take the beam into the target area.
    - Adjust H.E. steering, quads, tweaking magnet, etc. to maximize beam current.    - Adjust H.E. steering, quads, tweaking magnet, etc. to maximize beam current.
-   - Examine beam pick-off repetition rate;  if you have adjusted the chopper and buncher properly it should read 500,000 at f/1.+   - Adjust auxiliary width for beam current; this will affect both beam current and timing and will need to be set when the final timing is set.   
 +   - Examine beam pick-off repetition rate;  if you have adjusted the chopper and buncher properly it should read 5,000,000 at f/1.
    - If you are using a gold foil:     - If you are using a gold foil: 
       - put the cup in, then        - put the cup in, then 
playground/pulsing.txt · Last modified: 2023/01/27 07:11 by carter