User Tools
playground:pulsing
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
playground:pulsing [2009/04/15 14:35] odonnell Change numeration to use wiki formating |
playground:pulsing [2009/04/15 14:40] odonnell Minor changes to gold foil section; moved numbering to wiki format |
||
|---|---|---|---|
| Line 23: | Line 23: | ||
| - Adjust H.E. steering, quads, tweaking magnet, etc. to maximize beam current. | - Adjust H.E. steering, quads, tweaking magnet, etc. to maximize beam current. | ||
| - Examine beam pick-off repetition rate; if you have adjusted the chopper and buncher properly it should read 500,000 at f/1. | - Examine beam pick-off repetition rate; if you have adjusted the chopper and buncher properly it should read 500,000 at f/1. | ||
| - | - Put the cup in, then put gold foil in, then take out cup. Look at TAC output. Adjust chopper phase, buncher phase and amplifier plate to obtain best time tune. | + | - If you are using a gold foil: |
| - | - Take out gold foil. Run time-tuned beam. | + | - put the cup in, then |
| + | - put gold foil in, then | ||
| + | - take out cup. | ||
| + | - Look at TAC output. | ||
| + | - Adjust chopper phase, buncher phase and amplifier plate to obtain best time tune. | ||
| + | - put the cup in, | ||
| + | - take out gold foil | ||
| + | - take cup out. | ||
| + | - Run time-tuned beam to target | ||
| + | - Make final adjustments as necessary using detector timing if needed | ||
playground/pulsing.txt · Last modified: 2023/01/27 07:11 by carter
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
