User Tools
playground:power
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
playground:power [2010/08/02 13:19] 132.235.40.102 |
playground:power [2011/06/09 18:52] 132.235.40.233 Add source cooling water check to sputter source vacuum step (JEO) |
||
|---|---|---|---|
| Line 12: | Line 12: | ||
| {{playground:im001094s.jpg|}}{{playground:im001095s.jpg|}}{{playground:im003474s.jpg|}} | {{playground:im001094s.jpg|}}{{playground:im001095s.jpg|}}{{playground:im003474s.jpg|}} | ||
| - | 3) Return to the sputter source vacuum cabinet. Activate the systems by pushing the buttons indicated by the green arrows, from left to right, Fore Pump, Freon Compressor, Diffusion Pump, and, if those buttons have all turned green, the Baffle (gate) Valve. | + | 3) Return to the sputter source vacuum cabinet. Activate the systems by pushing the buttons indicated by the green arrows, from left to right, Fore Pump, Freon Compressor, Diffusion Pump, and, if those buttons have all turned green, the Baffle (gate) Valve. If the diffusion pump will not come on, check that the source cooling water is turned on. |
| {{playground:im003473s.jpg|}} | {{playground:im003473s.jpg|}} | ||
| Line 18: | Line 18: | ||
| 4) Proceed to the mechanical room. Stand at the yellow circle painted on the floor in front of the main breaker panel. Push the reset and start buttons on panels A, B, & C. This will activate 2 air handlers, and the water pump behind you. | 4) Proceed to the mechanical room. Stand at the yellow circle painted on the floor in front of the main breaker panel. Push the reset and start buttons on panels A, B, & C. This will activate 2 air handlers, and the water pump behind you. | ||
| - | + | ||
| {{playground:im001097s.jpg|}}{{playground:im001096s.jpg|}} | {{playground:im001097s.jpg|}}{{playground:im001096s.jpg|}} | ||
| - | + | ||
| 5) Return to the control room. Check the “main loop temp” on the alarm panel. If it is greater than 50 the chiller has failed and you will need staff to restart it. Do not re-start the accelerator, and turn down the magnets. | 5) Return to the control room. Check the “main loop temp” on the alarm panel. If it is greater than 50 the chiller has failed and you will need staff to restart it. Do not re-start the accelerator, and turn down the magnets. | ||
playground/power.txt · Last modified: 2020/07/12 13:43 by carter
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
